Project Phoenix Forums Project Phoenix Projects and Brainstorming Shot Put Toe Board

These are the dimensions we need:



The goal would be to design a toe stop that could be printed (without supports), and that could interlock together to form the whole assembly..~1 meter wide.

Here are some CAD drawings of a few different types of toe boards

https://www.sportsedge.com/track-equipment/shot-put-toeboards/





INSTALLATION INSTRUCTIONS
1. The SE364R toeboard is mounted to a flat throwing surface (pad) with a surface mount throw circle or painted
circle.
2. Using the toeboard as a template, mark the center of the holes to be drilled for the anchor studs. Be sure the
toeboard is properly positioned with the inside curved edge of the toeboard even with the inner edge of the ring.
The toeboard must also be centered on the sector lines.
3. Drill the holes for the anchor studs using a P3/8" masonry bit. Drive anchor into hole, taking care not to damage
threads, until approximately 3 1/8" inches of stud remain above the concrete. Mount toeboard to anchors using
the included 3/8" nuts and washers.

First prototype print. The dovetail joints are a bit too tight, and the overall size of the design needs to be broken down into smaller sections to accommodate the small build volume of the 3d printer.

Nice work, Mack!

Second prototype: