====== Printers ======
===== Geetech A10M ====
  * [[https://www.geeetech.com/Documents/A10M%20User%20Manual_V2.0.pdf|Manual]]
  * [[http://www.geeetech.com/forum/viewtopic.php?f=92&t=61760|Color Mixer Software]]


====== 3D Printing Problems ======


===== Setting Z-Offset =====
Heat your printer up to your printing temperature and allow a few minutes for it to expand and settle Reset the existing Z-offset to zero:

M851 Z0

Home all axes:

G28

Move the nozzle to the middle of the bed:

G1 X110 Y110

Turn off the software endstops with:

M211 S0

Move the nozzle down so it is just gripping a piece of standard printer paper Set the Z-offset to the displayed value. E.g. if the printer displays a Z-Value of -1.23 enter:

M851 Z-1.23

Store it to the EEPROM:

M500

MAKE SURE TO ENABLE THE ENDSTOPS AGAIN WITH:

M211 S1


===== Pillowing =====
  * [[https://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide#pillowing|Pillowing]]