3d_printer_ramps_1.4_conversion
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
3d_printer_ramps_1.4_conversion [2023/05/17 13:27] tjflowers23 |
3d_printer_ramps_1.4_conversion [2023/05/17 13:44] tjflowers23 |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| The instillation of the D2 diode was hard. My advice is to move the motor controllers off of the board for better air control and to bend one end of the diode so that it may fit and bend the ground so that it touches the top of the diode. | The instillation of the D2 diode was hard. My advice is to move the motor controllers off of the board for better air control and to bend one end of the diode so that it may fit and bend the ground so that it touches the top of the diode. | ||
| - | For the Marlin instillation I needed to download the U8glib-HAL library and enable it to work with the MKS_LCD12864A. When including the library make sure its in the lib folder and make sure you include it via the include library function in the Arduino IDE. | + | For the Marlin instillation I needed to download the U8glib-HAL library and enable it to work with the REPRAP_DISCOUNT. When including the library make sure its in the lib folder and make sure you include it via the include library function in the Arduino IDE. When compiling the program it can take 2 to 3 minutes |
3d_printer_ramps_1.4_conversion.txt ยท Last modified: 2023/05/23 14:24 by tjflowers23
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
