3d_printer_ramps_1.4_conversion
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
3d_printer_ramps_1.4_conversion [2023/05/23 14:18] tjflowers23 |
3d_printer_ramps_1.4_conversion [2023/05/23 14:24] tjflowers23 |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| *** When making wires it may be best to check ware they go and if that connection fits their(their are conflicting connections in Da Vinci Jr version to Mini so use your intuition on what connection for each end goes where) | *** When making wires it may be best to check ware they go and if that connection fits their(their are conflicting connections in Da Vinci Jr version to Mini so use your intuition on what connection for each end goes where) | ||
| - | Extruder heater, thermometer and fan are in place. Marlin is partially configured. | + | Extruder heater, thermometer and fan are in place. Marlin is partially configured |
3d_printer_ramps_1.4_conversion.txt ยท Last modified: 2023/05/23 14:24 by tjflowers23
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
